en:reference:language:for

差别

这里会显示出您选择的修订版和当前版本之间的差别。

@@ 行 1: / 行 1: @@
+====== for statements ======
+===== Description =====
+The for statement is used to repeat a block of statements enclosed in curly braces. An increment counter is usually used to increment and terminate the loop. The for statement is useful for any repetitive operation, and is often used in combination with arrays to operate on collections of data/pins.
+There are three parts to the for loop header:
+<code>
+for (initialization; condition; increment) {
+//statement(s);
+}
+</code>
+The initialization happens first and exactly once. Each time through the loop, the condition is tested; if it's true, the statement block, and the increment is executed, then the condition is tested again. When the condition becomes false, the loop ends.
+===== Example =====
+<code cpp>
+// Dim an LED using a PWM pin
+int PWMpin = 10; // LED in series with 470 ohm resistor on pin 10
+void setup()
+{
+  // no setup needed
+}
+void loop()
+{
+   for (int i=0; i <= 255; i++){
+      analogWrite(PWMpin, i);
+      delay(10);
+   }
+}
+</code>
+===== Coding Tips =====
+The C for loop is much more flexible than for loops found in some other computer languages, including BASIC. Any or all of the three header elements may be omitted, although the semicolons are required. Also the statements for initialization, condition, and increment can be any valid C statements with unrelated variables, and use any C datatypes including floats. These types of unusual for statements may provide solutions to some rare programming problems.
+For example, using a multiplication in the increment line will generate a logarithmic progression:
+<code cpp>
+for(int x = 2; x < 100; x = x * 1.5){
+println(x);
+}
+</code>
+Generates: 2,3,4,6,9,13,19,28,42,63,94
+Another example, fade an LED up and down with one for loop:
+<code cpp>
+void loop()
+{
+   int x = 1;
+   for (int i = 0; i > -1; i = i + x){
+      analogWrite(PWMpin, i);
+      if (i == 255) x = -1;             // switch direction at peak
+     delay(10);
+}
+}
+</code>